N CAUTION: Do not drain coolant until the coolant temperature is below operating temperature. Always loosen water pump drain valve (A) and block drain valve (B) slowly to relieve any excess pressure. Engine Tune-Up and Break-In/Check and Service Cooling System TS281 -UN-23AUG88 RG5836 -UN-28AUG91 IMPORTANT: Both water pump drain valve and block drain valve must be opened to completely drain both sides of the engine. 6. Remove and check thermostats. See REMOVE AND TEST THERMOSTATS in Group 25. 7. Drain and flush cooling system. See FLUSHING AND SERVICING COOLING SYSTEM in Group 02. IMPORTANT: Air must be expelled from cooling system when system is refilled.
Loosen temperature sending unit fitting at rear of cylinder head, bleed plug or petcock at top front of cylinder head, or plug in thermostat housing to allow air to excape when filling system. Retighten fitting or plug when all the air has been expelled. 8. Fill cooling system with coolant. Follow recommendations in Group 02. 9. Run engine until it reaches operating temperature. Check entire cooling system for leaks. 10. After engine cools, check coolant level. NOTE: Coolant level should be approximately 19 mm (3/4 in.) below bottom of radiator filler neck. 11. Check system for holding pressure. See PRESSURE TEST COOLING SYSTEM AND RADIATOR CAP in Group 105.
RG,CTM42,G100,3-19-29OCT92 100 9 CTM42 (24MAR95) 100-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=348