Engine System Operation and Test/How the Cooling System Works HOW THE COOLING SYSTEM WORKS Refer to illustration on the following page. The coolant flows toward the front end of the cylinder head where it passes through the outlet cavity and into the water outlet manifold (G) and thermostat housing. The pressurized cooling system consists of a conventional radiator (A), water pump (C), thermostats (H), and water outlet manifold (G).
If the coolant temperature in the thermostat housing is below the thermostat opening temperature, thermostats will remain closed (as during warm-up periods), causing coolant to be directed back through the bypass pipe (B) and into the water pump inlet to be recirculated through the engine. This provides a faster and more uniform warm-up. The pump draws low temperature coolant from the bottom of the radiator and discharges it through the water inlet manifold elbow (D), into the main coolant gallery (E) on the right-hand side of the engine.
Coolant from the main coolant gallery flows into the lower end of the engine oil cooler cavity (F), circulates around the oil cooler plates to cool the engine oil, and then flows out the upper end of the oil cooler cavity and into the cylinder block coolant jacket. If the coolant temperature in the thermostat housing is above the thermostat opening temperature, thermostats will be open (engine is at normal operating temperature) and coolant will flow through the thermostats into the thermostat cover and on to the radiator top tank to be cooled.
Coolant enters the coolant jacket near the rear of the engine, and flows around the cylinder liners progressing upward toward the cylinder head and forward from No. 6 cylinder toward No. 1 cylinder. As the coolant circulates around the cylinder liners, it carries excess heat away from the liners. On 6076A engines, coolant is taken from the upper left cylinder block and routed into the aftercooler (I) where it circulates through the aftercooler core and back out to the thermostat housing. Coolant circulating through the aftercooler absorbs heat from the pressurized intake air and carries the heat back to the engine cooling system to be dissipated through the radiator.
The coolant then flows through the block deck passages and cylinder head gasket into the cylinder head. Coolant passages in the block deck, cylinder head gasket, and cylinder head are sized to provide even coolant flow in all parts of the cylinder head. Upon entering the cylinder head, the coolant circulates through cavities around intake and exhaust ports, injector bores, valve guides and valve seats to keep all parts of the head at acceptable temperature levels. Two locations are provided for draining the coolant out of the engine. The block drain valve (J) is located in the center of the left-hand side of the cylinder block, and is used to drain the left side of the engine.
The water pump drain valve (K) is located on the bottom rear of the water pump, and is used to drain the right side of the engine (water pump, oil cooler, main coolant gallery). CTM42,G105,24 -19-29OCT92 105 10 CTM42 (24MAR95) 105-10 6076 Diesel Engines—S.N. (500000— ) 160101 PN=359