Engine System Operation and Test/Head Gasket Inspection and Repair Sequence **M:CTM42,G105,18 -19- HEAD GASKET INSPECTION AND REPAIR SEQUENCE RG6448 -UN-13OCT92 A—Combustion Seals B—Gasket Body D—Elastomer Beading Strips E—Front of Engine (Flanges) C—Rocker Arm Oil Port The following inspection procedures are recommended whenever a head gasket joint failure occurs, or when joint disassembly takes place. 5. Observe surfaces of removed head gasket. Examine combustion seals (A) for the following: • Flange severed/expanded/cracked/deformed. • Adjacent body area burned/eroded. • Fire ring severed/displaced/missing. • Flange sealing pattern eccentric/contains voids.
• Discoloration of flange and adjacent body areas. • Flange surfaces rough/abraided/channelled. 1. Review historical data relating to machine operation, maintenance and repair, along with diagnostic observations. Note all areas requiring further inspection and analysis. 2. Remove rocker arm cover and check for presence of coolant in the oil. Examine gasket body (B) for the following: • Combustion gas erosion paths or soot deposits originating at combustion seals. • Extreme discoloration/hardening/embrittlement in localized areas. • O-ring seal missing/damaged in port area (C). • Elastomer missing/damaged in port areas (D). • Oil or coolant paths from port areas.
• Localized areas of low compression. 3. Record head cap screw torques prior to removal. Upon removal, check cap screw length differences. 4. Remove cylinder head using appropriate lifting devices to prevent handling damage to head gasket. See REMOVE CYLINDER HEAD in Group 05. 6. Before cleaning components, inspect head, block, and liners for evidence of combustion gas and fluid leakage. Inspect cylinders and valve ports for unusual deposits. 105 17 CTM42 (24MAR95) 105-17 6076 Diesel Engines—S.N. (500000— ) CTM42,G105,17 -19-08APR94 160101 PN=366