Air Intake System Operation and Test/Air Cleaner Operation HOW THE AIR INTAKE AND EXHAUST SYSTEM WORKS 110 4 Engine suction draws dust-laden outside air through an air inlet stack into the air cleaner. Air is filtered through dry type primary and secondary (safety) filter elements in the air cleaner canister. Clean air travels through the air intake hose to the turbocharger and intake manifold to the engine. On 6076H Engines, an air-to-air aftercooler cools the turbocharger compressor discharge air by routing it through a heat exchanger before it enters the engine. The heat exchanger uses no liquid coolant but relies on air flow to cool the charge air.
This increased volume of air, when combined with a predetermined quantity of additional fuel, enables more power to be produced. Exhaust, as it is expelled out the exhaust elbow, drives the turbocharger to deliver a larger quantity of air to meet the engine requirements than what could be delivered under naturally aspirated (non-turbocharged) conditions. On 6076A Engines, intake air, which has been compressed (and heated) by the turbocharger, flows around the aftercooler and lowers the air temperature as much as 27—32˚C (80—90˚F) before entering the engine cylinders.
Lowering the air temperature makes the air more dense and permits an even greater volume of air to be delivered to engine cylinders for combustion. RG,CTM42,110,3 -19-29OCT92 AIR CLEANER OPERATION Dust-laden air enters the air cleaner inlet (A) and is forced into a high-speed centrifugal motion. Most of the dust settles out of the air (before it enters the filter elements) and falls to the bottom of the air cleaner body. It is expelled to the outside of the air cleaner (B) through a rubber valve, which automatically ejects the dust and keeps it from accumulating inside the air cleaner body.
R28270 -UN-14DEC88 As the intake air is drawn through the primary element (C) and a secondary (safety) element (D), the remaining dust particles are retained in the primary element to A—Air Inlet B—Dust Outlet permit only clean air to enter the intake manifold. C—Primary Element D—Secondary (Safety) Element The safety element retains the dust that would otherwise E—Air Outlet pass into the engine if the primary element should rupture. See your operator’s manual for recommended service intervals. CTM42 (24MAR95) 110-4 6076 Diesel Engines—S.N. (500000— ) S11,23005,AO -19-04FEB93 160101 PN=377