Fuel System Operation and Test/How the Hydraulic Aneroid Activator Works HOW THE HYDRAULIC ANEROID ACTIVATOR WORKS (IF EQUIPPED) The hydraulic aneroid activator mounts on the inboard side of the governor housing. It has an internal piston (F) that is operated by engine oil pressure to hydraulically move the starting fuel control shaft inward for aneroid control. 115 44 R27342N -UN-14DEC88 Engine lubricating oil is piped from the oil filter body to operate the activator. This oil is then piped to the injection pump housing to lubricate the internal working parts.
Engine oil upon starting the engine is routed to the aneroid activator housing (I) through a banjo connector (A), special screw (B), and an orifice in the capillary A—Activator Banjo Connector valve (E) to head of piston (F). B—Special Screw C—Capillary Valve Spring Whenever the engine oil pressure is about 60 kPa (0.6 D—Restrictor Wire E—Capillary Valve bar) (9 psi) or higher, the piston will overcome resistance F—Piston of piston spring (G) and move the starting fuel control G—Piston Spring shaft (H) inward to provide aneroid control.
H—Starting Fuel Control Shaft I—Activator Housing Loss of oil pressure permits a return spring on the starting fuel control shaft to hold the lever arm out of engagement with the control rack. This prevents the aneroid from limiting rack travel. A restrictor wire (D) is inserted in the capillary valve for two reasons. (1) To retard engagement of the aneroid when engine is cold. (2) To help maintain an open passage in the capillary valve (oil pressure action moves the wire enough to prevent orifice from plugging). The length of time required to achieve aneroid control depends on the ambient air temperature and the viscosity of the engine oil.
Warm ambient air temperatures will permit the aneroid to activate in a few seconds. Cold temperatures may delay activation for several minutes. CTM42 (24MAR95) 115-44 6076 Diesel Engines—S.N. (500000— ) S11,23010,AB -19-28OCT92 160101 PN=427