Komatsu — 12.13 ADJUSTMENT QF WORK EQUIPMENT

12. OPERATION 12.13.2 RIPPER ADJUSTMENT ADJUSTING DIGGING DEPTH There are mounting pin holes in the shank, and these can be changed to match the digging depth. For normal oper- ations, use the bottom hole; for particularly deep digging, use the top hole. When changing the digging depth, refer to “12.12.2 METHOD OF PIN-PULLER CONTROL of OPERATING RIPPER”. REPLACING POINT AND PROTECTOR If the point and protector installed to the tip to protect the shank are worn, replace them. Using a hammer and punch against the point marked by the arrrow, knock out and remove from the opposite side. REMARK The pin is a unitized type, so insert the pin partially by hand, then knock it in fully with a hammer.

2-68