13. HANDLING ACCUMULATOR The accumulator is installed to the side face of the blade valve (2 places) and the rear face of the ripper valve (1 place). A WARNING The. acuumulator is filled with high-pressure nitrogen gas, and it is extremely dangerous if it is handled in the wrong way. Always observe the following precautions. If there is any-failure or problem wi% the accumula- tor, contact your Komatsu distributor immediately. The charging of the gas should be carried out only by a Komatsu distributor serviceman or by a person licensed to handle high-pressure gas. Do not hit or bring an accumulator charged with gas near any flame. Do not weld any piping or make any hole in the accu- mulator.
l When disposing of the accumulator, it is necessary to release the gas from the accumulator, so please con- tact your Komatsu distributor. Once a year, contact your Komatsu distributor to have the gas pressure checked. 13.1 RELEASING REMAINING PRESSURE IN ACCUMULATOR CIRCUIT After stopping the engine, set safety lock 0 to the FREE position, then operate each work equipment control lever 3 or 4 times to the end of its stroke. The remaining pressure will be released after one minute. REMARK Always wait for at least one minute after releasing the pressure. Never start to loosen any piping before one minute has passed. 2-75