Komatsu — 16.3 OTHER TROUBLE

16.3.2 CHASSIS Problem Main causes Remedy Oil pressure in torque converter fails to rise l Improper tightening of oil pipe, pipe joint, air leaking in or oil leaking out because of damage (0 Check, repair) l Wear, scuffing of gear pump (0 Check, replace) l Insufficient oil in transmission case l Add oil to the specified level. For details, see CHECK BEFORE STARTING l Clogged oil filter element strainer in transmission case l Clean.

For details, see EVERY 1000 HOURS SERVICE Torque converter is overheats l Clogged radiator l Clogged oil cooler (0 Clean or replace) (0 Clean or replace) l Oil pressure too low l Lack of flow of lubricant caused by wear of power train gear pump l Go to “Oil pressure in torque con- verter fails to rise” (0 Replace gear pump) (0 Replace fan pump motor) l Lack of flow of lubricant caused by wear of fan pump motor Torque converter oil tempera- ture gauge does not work l Defective oil temperature gauge (0 Replace oil temperature gauge) l Defective contact in wiring connection (0 Check, repair) Lacks drawbar pull (machine does not pick up speed) l Lack of engine horsepower l Oil pressure in torque converter is too low l See Engine related parts l Go to “Oil pressure in torque con- verter fails to rise” (0 Check, repair) l Steering clutch is slipping Machine doesn’t start by engaging the gear shift lever l Lack of oil in steering clutch case l Add oil to the specified level.

For details, see CHECK BEFORE STARTING l Steering clutch slips verter fails to rise” l Transmission oil pressure does not rise l Go to “Oil pressure in torque con- 0 Wear, scuffing of gear pump (0 Check, replace) 0 Clogged oil strainer element in 0 Clean.

For details, see EVERY steering clutch case 1000 HOURS SERVICE When steering lever on one l Brake is not applied on side which is side is pulled, machine con- pulled tinues to travel straight forward instead of turning (0 Adjust linkage) (0 Check brake pressure) Machine doesn’t stop when brake pedal are depressed l Defective brake adjustment (0 Adjust linkage) (0 Check brake pressure) Track comes off l Track is too loose l Adjust track tension. For details, see WHEN REQUIRED. Sprocket develops abnormal wear l Track is too loose or too tight l Adjust track tension. For details, see WHEN REQUIRED.

Brake rises too slowly or does not rise at all (or blade tilts too slowly) l Lack of hydraulic oil l Add oil to specified level. For details, see EVERY 250 HOURS SERVICE Ripper moves too slowly l Lack of hydraulic oil l Add oil to specified level. For details, see EVERY 250 HOURS SERVICE Insufficient force of ripper l Leakage from piping 1 (0 Tighten) 2-86