24. SERVICE PROCEDURE 5. Grease may be pressurized till S will be 916 mm (3.0 ft). In case the tension is yet loose after applying pressurized injection of grease till the abovementioned limit, it indi- cates that the pin bush is reduced by too much abrasion. So it is necessary either to turn or replace the pin and bushings. Consult your Komatsu distributor for repair. l When loosening tension A WARNING It is extremely dangerous to release the grease by any method except the procedure given below. If the track tension is not relieved by this procedure, please contact your Komatsu distributor. 1. Loosen plug 0 gradually to release the grease. 2. Turn plug 0 a maximum of one turn. 3.
If the grease does not come out smoothly, move the ma- chine backwards and forwards a short distance. 4. Tighten plug 0. 5. To check that the correct tension has been achieved, move the machine backwards and forwards. 6. Check the track tension again, and if the tension is not correct, adjust it again. 3-30