Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.10 CHECK ETHER SPRAY, REPLACE ETHER CYLINDER A WARNING Never bring close to any fire or flame during the inspection. Be particularly careful of the following when handling the ether cylinder. Never bring it close to any fire or flame. Never throw any used cylinder into a fire or make any hole in it. Do not store it in a place where the temperature goes above 40°C (104°F). Do not breathe in ether gas or let it get on your body. Never keep any ether cylinder in the operator’s com- partment. Always keep ether cylinders out of the reach of children. In summer or other seasons when the ether cylinder is not being used, remove it from the machine.

If the temperature will go below -20°C (-4°F). remove the ether cylinder from the machine and keep it at room temperature until it is needed again for starting the engine. 1. Remove bolt 0, then remove cover 0 at the rear of the engine hood. Loosen wing nut 0, then remove ether cylinder 0. To prevent dirt or dust from entering the valve, wipe off all dirt or dust from around the inlet port of the valve be- fore removing the ether cylinder. Operate the quick start switch and check that the control cable and valve work. Remove tube 0 from atomizer 0, then remove atomizer 8 and connect tube 0 again.

Install the ether cylinder, push the quick start switch for 2 or 3 seconds, then release the quick start switch and check that a fire spray of ether comes out from each ori- fice of the atomizer. After checking, assemble atomizer 8 and tube 0 to their original places. If any abnormality is found, please contact your Komatsu distributor, L 2. 3. 4. 5. 6. 3-37