24. SERVICE PROCEDURE 24.4 EVERY 250 HOURS SERVICE 24.4.1 LUBRICATING 1. Lower the work equipment to the ground, then stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. 1. Equalizer bar side shaft (4 places) Remove the plugs on the two inside points and add grease through the fittings (%) on the inside. 2. Equalizer bar center shaft (1 place) 3. Blade lift cylinder support shaft and yoke (6 places) 4. Blade arm ball joint 5. Blade oblique arm ball joint (3 places) (2 places)