Komatsu — 27.1 FASTEN THE BELT AND REMOVE IT IN THE FOLLOWING MANNER

27. USING SEAT BELT When operating a machine equipped with ROPS, be sure to use the seat belt. A WARNING l Before fastening the seat belt, inspect the securing brackets and belt for abnormal conditions. Replace any worn or damaged seat belt or the secur- ing brackets. l Adjust and fasten the seat belt before operating the machine. l Always use seat belt when operating the machine. l Fit the seat belt across your lap without twisting. 27.1 FASTEN THE BELT AND REMOVE Ie IT IN THE FOLLOWING MANNER 1. Adjust the seat so that the brake pedal can be depressed all the way with the operator’s back against the backrest. 2. After positioning the seat, adjust the tether belt 0.

With the seat unoccupied, tense the belt slightly across the seat and install. 3. Sit in the seat, hold the tongue of reel 0, and pull the belt out slowly to a length which fully covers your lap. 4. Insert the tongue into buckle 0 and push until there is a click. Pull back reel 0 until the belt fits securely across your lap. In this condition, the lock is applied to prevent the belt from extending any further. Fit the seat belt across your lap without twisting. AD053730 REMARK If the lock is applied before the tongue is installed into the buckle, return the belt to the reel, then carry out the oper- ation again from the beginning. 5. Tense the belt and check that the lock is applied. 6.

To remove the belt, press the red button on buckle 0. The belt will automatically wind in. Inspect bolts and fittings on the chassis for tightness. Re- tighten any loose bolts to 19.6 to 29.4 Nm (2 to 3 kgm, 14.5 to 21.7 Ibft) torque. If the seat is scratched or frayed or if any of the fittings are broken or deformed from long service, replace the seat belt immediately. 5-3