Komatsu — 12.12 OPERATING RIPPER

12.12 OPERATING RIPPER 12.12.1 HINTS FOR EFFECTIVE RIPPING The most suitable digging angle for the shank is with the shank tilted about 5” to the ground surface (ripper point angle: 45” to 50”). When digging relatively soft rock (seismic wave 1500 m/set or below), keeping a shank in tilted back posture is allowed. When digging relatively hard rock, a shank should not be left in tilted back posture. Otherwise, point tip 0 will wear early, caushing low self- shapening effect. If slippage of the tracks is found during ripping operation, existence of a boulder or rock is assumed. Pick up such an obstacle by manipulating the tilt cylinder.

When picking up a stone, advance the machine at a fixed gear speed (Fl or F2). REMARK When raising boulders or digging up rockbed, do not put the transmission in neutral. If the transmission is in neutral, the reaction of the tilt cylinder will push the machine back. Al- ways operate the machine with the transmision in FORWARD. REMARK Selecting a suitable ripper point to match the rock condi- tions is extremely important to ensure effective use of the ripper. 2-63