MAINTENANCE BUCKET BOLT-ON CUlTlNG EDGE - IF EQUIPPED If the bolt-on cutting edge is worn, turn the edge. 1. Raise the bucket to a convenient height, and put blocks under the bucket to prevent it from coming down. * Raise the bucket so that the bottom is horizontal. 2. Loosen nut (1) and remove bolt (2). Then, turn the cutting edge. 3. Exchange cutting edges (3) and (4), and install edge (5) in the opposite direction. 24 Ll7DRO05 4. After exchanging, tighten with bolts (2) and &rts (1). Tightening torque: 40 - 54 kgm When installing the edge to the bucket, clean the mounting surface. After the edge has been turned once, replace it with a new part. :
* BUCKET TEETH - IF EQUIPPED BUCKET IS EQUIPPED WITH BOLT-ON TEETH When the bucket teeth are worn, replace them as * After operating the machine for a few hours, follows. tighten the mounting bolts again. 1. Raise the bucket to a convenient height, and put blocks (A) under the bucket to prevent it from coming down. * Position the bucket so that the bottom is horizontal. 2. Remove the mount bolts and nuts (1) and bucket teeth (2). 3. Install the new teeth on the bucket. When install- ing each tooth, insert a shim(s) so that there is no clearance between the tooth and the top surface of the bucket.
* Continue to adjust with shims until it becomes impossible to insert a shim of thickness 0.5 mm. 4. To prevent any clearance between the tooth and the edge of the bucket, tighten the mount nut partially, then hit the tip of the tooth with a hammer. * Tightening torque of mounting bolts: B4*3 kgm 3-31