Komatsu — ENGINE OIL PAN AND FILTER

MAINTENANCE ENGINE OIL PAN AND FILTER I. Warm up the engine to operating temperature and the trun the engine off. A WARNING! If oil filter (2) is removed immediately after stopping the engine, oil will spill. Wait at least 10 minutes after stopping the engine before replacing the filter. 2. Open the engine side covers located on the left and right of the engine hood. 3. Open oil filler (F) and remove drain plug (1) to drain oil. After draining, tighten the drain plug. I Ll2ADOQ! 4. Clean the area around the oil filter. 5. Using a filter wrench, remove oil filter (2) by turn- ing it counterclockwise. 6. Clean the filter gasket surface of the filter header. 7.

Fill a new oil filter with engine oil. Then, apply engine oil or a thin coat of grease to the seal. 8. To install filter, bring its seal surface into contact with sealing surface of filter base and then tighten the filter l/2 to 3/4 turn by hand. L12ZZ161 * Be careful not to tighten it up excessively. * Be sure to use a genuine filter. 9. After replacing the filter, pour in the quantity of engine oil at oil filler (F). * Refill capacity is 9.5 Q (2.5 US gal). * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS.” I I Ll2AMOlI * Replace once every 3 months, regardless of the number of hours operated. 3-40