Komatsu — ENGINE VALVES

MAINTENANCE 3. When pin (2) engages the hole in camshaft gear (3), cylinder number 1 is at TDC on the compression stroke. A WARNING! Be sure to disengage pin (2) after locating TDC. : ; Check and adjust the valves indicated by “I” and “E” (I - Intake; E - Exhaust). Intake clearance: 0.254 mm Exhaust clearance: 0.508 mm Check and set valves with engine cold - below 60” C. * The clearance is correct when some resis- tance is “FELT” when feeler gauge (4) is slipped between the valve stem and the rocker lever. Tighten the lock nut to 2.46 kgm and re-check the valve lash. I U22216E i E I E I E I