9. EXPLANATION OF COMPONENTS OPERATION 9.1.1 CONTROL LEVERS Proportional control is used for operation of the control levers, so it is possible to control the speed according to the amount the levers are operated. In addition, any combination of levers can be used at the same time. Right control lever (1) :Keep the push button pressed and operate fully to the blade LOWER position. 2 :For details of the method of operating the pin-puller, "OPERATION METHOD FOR PIN-PULLER USING RADIO CONTROL(3-8 page)". REMARK Use the toggle switch on "SWITCHES(3-10 page)" to switch between the blade and ripper. When in the FLOAT condition, press the push button switch to cancel the FLOAT.
If the blade lever is operated to the RAISE position from FLOAT, the FLOAT is canceled. Left control lever (1) When the push button is pressed, the brakes are applied, regardless of the position of the control levers. When the travel direction is set to neutral, the brakes are applied.
3-6 Direction of operation Front / rear direction Left / right direction Push button Right control lever (1) Blade or ripper operation Blade or ripper operation Blade or ripper operation Push Pull Left Right 2 Blade LOWER / ripper DOWN Blade RAISE / ripper UP Left tilt / ripper tilt in Right tilt / ripper tilt back Blade FLOAT/pin- puller pull out Direction of operation Front / rear direction Left / right direction Push button Left control lever (1) Travel operation Steering operation Brake operation Push Pull Left Right ON (push) Forward Reverse Left turn Right turn Brake