Komatsu — 10. HANDLING RADIO CONTROL

10. HANDLING RADIO CONTROL OPERATION 10. HANDLING RADIO CONTROL To ensure that the radio control operations can be carried out safely, they must be carried out in the following order. If this order is not followed, the radio control cannot be operated, so be sure that you fully understand the correct order before operating.

Checks before starting Set radio control/on-board selector switch to RADIO CONTROL Set fuel control dial inside cab to MIN position On-board operation (Turn switch on machine to ON position) Turn starting switch ON 1 Set parking lever on left side of operator's seat to FREE position (raised) 2 Transmitter power ON 1 When this is done, the spee range display on the monito panel shows "PR". Start engine Start radio control operation 2 When this is done, the spee range display on the monito panel shows "NR". Radio control operation 3 When this is done, the engi stops.

Emergency stop, radio control power OFF Set parking lever to LOCK position (lowered) Turn starting switch OFF (on machine) On-board operation Set radio control/on-board selector switch to ON-BOARD Checks after finishing 3-16