. OPERATION OPERATION ADJUSTING MIRROR WARNING Rear monitor (if equipped): Must be possible to see hatched portion (H) 3 - 87 Be sure t o adjust t he mirrors before starting work. If they a re not adjusted properly, you cannot secu re the visibility and may be injured o r may inju re someone serio Loosen the bolt and nut installing the mirror, then adj ust the mirror to a pos ition whi ch gives the bes t view from the ope rator's seat. Adjus t the po sition and angle of each mirror so th at it reflects a sight 200 mm above the gro und and up to 150 0 mm.
In the adjustment, m ake sure that pa rt of the dump truck 's image also come s into vi Rang e of visib ility t be possible to see hatched portion (A), area Mirror A: Mus arou grou Mirror B: Mus Mirror C: Mus of th Mirror D: Mus arou grou body Mirror E: Mus porti cont edge Mirror F: Must the machine Mirror G: Mus of the machin Mirror A: Mus nd point (A') wh ere the tire contact s the ground, nd surface (A'') a nd the top edge of th e dump body Mirro r B:
Mus t be possible to s ee hatched portion t be possible to e machine t be possible to see hatched portion (D), area nd point (D') where the tire contacts the ground, nd surface (D'') and the top edge of the dump ere the tire contact s the ground, t be possible to see hatched portion (E), hatched on (D), area ar ound point (D') w tire acts the ground, ground surface (D' top of the dump bo Mirro r F: Must be possible to s ee hatched portion ( F) and part of the m achine Mirro r G: Mus t be possible to see hatched portion (G) and part of the machin e