. MAINTENANCE SERVICE PROCEDURE Inflation of tires WARNING Tire size Inflation pressure [MPa (kg/cm 2 , PSI)] 24.00-35-36PR (standard) 0.47 to 0.50 (4.75 to 5.05, 67.4 to 71.7) 24.00R35 aa (if equipped) 0.69 to 0.72 (7.0 to 7.3, 99.4 to 104) HD605-7 Tire size Inflation pressure [MPa (kg/cm 2 , PSI)] 24.00R35 aa (standard) 0.69 to 0.72 (7.0 to 7.3, 99.4 to 104) 24.00-35-48PR (if equipped) 0.64 to 0.67 (6.5 to 6.8, 92.3 to 96.6) PRECAUTIONS WHEN REPLACING TIRE If the hub nuts (1) have been tightened again after replacing the tire, travel for 5 to 6 km, then tighten again to settle all the contacting parts.
In particular, there are more contacting parts on the rear wheels than on the front wheels, so it will take time for the parts to settle. For this reason, repeat the tightening process for the first 50 hours after installation. 4 - 48 Always maintain the ti re inflatio n pressure at the s pecified value . If the tire i s not at the pro per inflation p ressur e, the rim will be damaged. If t he r im is d amaged, there i s danger tha t the ring may fly off w hen the tire is inflate d and cause serious persona l injury. Adjust the i nflation p ressure When inflating a tire , use an air chuck which can be fixed to the air valve of the tir e as shown in the figure.
Do not work a t the side fac e of tire b ut work o n the t read side of the tir The p roper inflation pressure is shown below HD465-