. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE the inside of the filter lbft} 4 - 65 5. Clea n transparent cup ( 3) and remove seal (4). Coat the new seal with clean fuel or o 6. Insta ll transparent cup ( 3) to the new filte r cartrid Tightening torque for cu p: 10 Nm {1.0 kgm, 7.2 l t is not ne cessary to fill the filt er cartridge with oil. Cap (A) is cartridge. Whe n replacing the filte r cartridge, check that dra in plug ( 5) at the b ottom of transpare nt cup (3) is securely tigh tened. Tightening torque: 0.2 t o 0.4 Nm {0.02 to 0.046 k gm, 0.1 to 0.3 7. Clea n the filter holder. e of the filter cartridge with oil. cap (A) and install to the filter holder. 8.
Coat the packing surfac 9. Remove filter cartridge cap (A) and instal l to the filter hold 10. Whe n installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn . If the filter cartridge is tightened too far, the pa of fuel cking wil l be damaged and this will lead to leakage . If the filter cartridge is too loose, f uel will also leak from the packing, so ct amount. he fuel tank. alwa ys tighten the corre 11. Open fuel valve (1) on t