. MAINTENANCE SERVICE PROCEDURE ° F), bleed the air from the brakes. NOTICE oil level so that it reaches the 4 - 75 20. Remov e the cap from bleeder screw (10) and insert a vinyl commercially available vinyl hose.) e other end of the vinyl hose approx. 50 mm into a er of oil. bleeder screw (10) approx. 3/4 turns and run the at low idling until no more bubbles come out from the ose. no more bubbles come out, tighten bleeder screw (10) ly, remove the vinyl hose, then install the cap. hose. (Use a 21. Put th contain 22. Loosen engine vinyl h 23. When secure 24. Perfor m the warming-up operation of the engine until the torque c 40°C ( 104°F). 25.
When t he torque converter oil temperature gauge rises to 40°C (1 Front b rake: See "BLEED AIR FROM FRONT BRAKE (PAGE 4-4 Rear b rake: See "BLEED AIR FROM REAR BRAKE (PAGE 4-41) Parkin g brake: See "BLEED AIR FROM PARKING BRAKE (PAG Do not at tempt to use the oil drained during air bleeding again. Such a pract equipmen Make sur e that the oil level in the brake oil tank does not go down below (H does, the 26. After fi specifi ed level. For details, see "CHECK OIL LEVEL IN TRANSMI 27. Check the oil level in the brake sub-tank and adjust the oil level so t see "C HECK OIL LEVEL IN BRAKE SUB-TANK, ADD OIL (PAGE