. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) When displaying the payload in 1) or 2), it is possible to input, correct, or set the displayed completion of loading (when traveling 160 m with at least 50% of the set payload loaded or when dump), not the real-time payload. 6 - 74 SERVICE CHECK MODE k mode, it is possible to carry out display, setting, and correction forc ethod of operation and setting, please ask your Komatsu distributor. By If it is designed to correct the m ethod of operation and setting, please ask your Ko matsu distributor of the (a) Detailed display of calibratio n data This display shows the data , suspension pressure, etc.
for the late st calibration (b) Detailed display of payload calculation data (analog data) The display shows the susp ension pressure and machine angle w hen calculati ng the presen t paylo (c) Memory card dump (service This writes all the data displ ayed for (a) and (b) to the memory car d installed in the body. (d) Data all clear (service area) This forcibly deletes (a) cali bration data and (b) analog data, exce pt for the late st calibration d (e) Input signal status display This displays some of the si gnal status for the sensors input to th e payload me ter and the present r ecognition status display of the payloa d meter.
(f) This forcibly deletes all the d (g) Extra payload setting when The extra load for the paylo ad can be forcibly input, corrected, or set when loa (h) Payload fixed display and c ycle data recording, payload value set 1 . The payload fixed display 1) When TALKS is not set: Time that machine is stopped after trav eling 160 m with at l east 50% of s et payload loaded until starting to dum p e that machine is stopped from permission to move off until starting to dump 2) When TALKS is set: Tim e that machine is stopped from permis sion to move off unt il starting to d ump yloa and startin to 2 .
Cycle data recording, swit ching payload value If the payload fixed display in Item 1 above is applicable, this inpu ts, corrects, or sets the payload i n the cycle data to the fixed display pa yload value. (i) Setting loading completion r ecognition travel distance T his inputs, corrects, or sets the travel distance recognized as com pletion of loa ding by the payload meter. (j) Setting loading start recognit ion payload T his inputs, corrects, or sets the payload recognized as the start of loading by t he payload meter (k) Setting 0 ton display range This inputs, corrects, or sets the range for the zero display on the payload disp