. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) 6 - 85 OPERATION WHEN ERROR CODE F.CAL IS DISPLAYED OR CONTROLLER HAS BEEN REPLACED I f F.CAL is displa yed, mistaken datahave pro bably been written to t he memory ins ide the p ayload m eter . In addition, when t he control ler is replaced , old data may be recorded to the ne w controller, or the machine condition recognised by the controller may be differ ent from the a ctual condition. To pr event removin g this data, d o as follows. 1. Forcibly carr y out initializa tion. For deta ils, see "CARRYING OUT FORCED INITIALIZATIO N (PAGE 6-86)". 2.
Using the op erator check mode, set the machine ID , open ID, speed limit, o ption code, date and ti me 3. Without turn ing the startin g switch to the OFF position, start th e engine. (F.C AL may 4. Carry out ca 5. Load to nea r the rated pay load, then du mp the load. 6. Move the m achine to a saf e place, wait f or at least 5 sec . after dumping the lo ad in Step 7, then stop the engine. 7. Turn the sta rting switch to the ON positi Do not start the engine wh en doing this. 8. Carry out th e DATA ALL C LEAR in the operator check mode. 9. Forcibly clea r the data for the total paylo ad and overall numbe r of cycles.
With this op eration, all the mistaken data inside the p ayload m eter are cleare d. Apart fro m the calibration data, all the data r ecorded in the Steps 3 to 8 (these data are all ina ccurate data) are also deleted. If t his opera tion is carried out in the wro ng order, the cycle da ta (beginning o nly) will be defective. After the ab ove operation i s completed, the payload meter wil l function norm