Install the distribution shaft. Direction of fixed flange (camshaft keyway) (As viewed from driving side) Inserting distribution shaft Insert distribution shaft so that the directional relationship between the shaft and camshaft is as shown below (Do not assemble upside down). Use the following drawing simply as a reference because the component can be inserted in either of two orientations. Insert the component securely into the distribution shaft joint until it is sunk below the end surface of the distribution shaft sleeve. Measure the plunger top position. 3.3.4. Assembling the Hydraulic Head Bottle clearance adjustment should refer to Page 59. Install the accumulator.
Upper side Attaching accumulator ! Be sure to install the piston in the correct Camshaft keyway Operating side Anti-operating side direction. ! Make sure that the piston can slide smoothly. Flange cutout Lower side Direction of distribution shaft longitudinal groove (As viewed from upper side Distribution shaft longitudinal groove, cut off surface Install the spring, (accumulator). Governor side Operating side Anti-operating side Driving side Install the plug with new seal washer, (accumulator). 35