. OPERATION TRANSPORTATION position (L). NOTICE 3 - 161 The mach ine can be lifted only if it has hook mark labels. When liftin g the machine, stop the machine on level ground and do 1. Start t he engine, make sure t hat the machine is horizontal the travel posture. MACHINE (PAGE 3-126)". then s et the work equipment to For de tails, see "MOVING THE MACHINE (PAGE 3-126)". (A): 40 - 50 cm (16 - 20 in) 2. Check that the work equipme nt control lever is at the HOLD positio n, then set the work equ LOCK 3. Stop t he engine, check that t he area around the operator's compartment is safe, then set t he frame lock bar to the LOCK position (L) to prevent the fro articulating.
nt frame and rear frame from 4. Use w ire ropes and slings that match the weight of the machine , and wind the wire ro pe and fix it to the lifting points as shown in the figure. Use prot ectors, etc. so that the wire ropes will not be broken at sharp Use thre aders and bars having suffi cient width so that the sling s and wir e ropes will not touch the For mac hines equipped with a rear f ull fender, remove the rear f ull fender before carrying out the 5. Before lifting up the machine, s et the slings and float the machine to 100 mm - 200 mm a bove the ground. Make sure th at the wire ropes are no t slack and the machine i s kept horizontally, and then lift up the machine slowly.