Komatsu — 24.3 CHECK BEFORE STARTING

24. SERVICE PROCEDURE 24.3.3 CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the upper cover at the rear of the engine hood. 2. Remove dipstick @ and wipe the oil off with a cloth. 3. Insert dipstick @ fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0. NOTICE For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 5. If the oil is above the H mark, drain the excess engine oil from drain plug 8, and check the oil level again. 6.

If the oil level is correct, tighten the oil filler cap securely and close the engine side cover. REMARK l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. l If the machine is at an angle, make it horizontal before checking. AD052340 24.3.4 CHECK OIL LEVEL IN TRANSMISSION CASE, ADD OIL 1. Open the cover, remove dipstick 0, and wipe the oil off with a cloth. 2. Insert dipstick @ fully in the oil filler pipe, then take it out again. 3. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0.

NOTICE For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 4. If the oil is above the H mark, drain the excess engine oil from drain plug @, and check the oil level again. 5. If the oil level is correct, tighten the oil filler cap securely and close the cover. REMARK l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. l If the machine is at an angle, make it horizontal before checking. 3-35