A WARNING: Failure to follow these safety precautions may lead to a serious accident. 7. PRECAUTIONS DURING OPERATION Traveling on slopes could result in the machine tipping over or slipping to the side. When traveling on slopes, keep the blade approximately 20 to 30 cm (8 to 12 in) above the ground. In case of emergency, quickly lower the blade to the ground to help the machine to stop. Do not turn on slopes or travel across slopes. Always go down to a flat place to perform these operations. Do not travel on grass, fallen leaves, or wet steel plates.
Even slight slopes may cause the machine to slip to the side, so travel at low speed and make sure that the machine is always traveling directly up or down the slope. When traveling downhill, use the braking force of the engine and travel slowly. Be careful when allowing the machine to travel downhill under its own weight. It may steer in the opposite direction. Reverse steering when traveling downhill + See “12.7.2 TURNING WHILE DESCENDING A SLOPE”. AD051690 1 PROHIBITED OPERATIONS 1 To prevent the machine from turning over or the work equipment from being damaged because of overload, always keep within the safe angle and maximum load specified for the machine.
Never use the machine in excess of its capacity. -j PRECAUTIONS WHEN -1 Be careful not to approach too close to the edge of cliffs. When making embankments or landfills, or when dropping soil over a cliff, dump one pile, then use the next pile of soil to push the first pile. The load suddenly becomes lighter when the soil is pushed over a cliff or when the machine reaches the top of a slope. When this happens, there is danger that the travel speed will suddenly increase, so be sure to reduce the speed. If the load is applied to only one side of the blade, the rear of the machine may swing. Carry out only work that is specified as the purpose of the machine.
Carrying out other operations will cause breakdowns. Specified operations + See “12.10 WORK POSSIBLE USING BULLDOZER”. Do the following to ensure good visibility. l When operating in dark places, turn on the working lamps and front lamps, and install lighting at the jobsite if necessary. l Do not carry out operations in fog, mist, snow, or heavy rain, or other conditions where the visibility is poor. Wait for the weather to clear so that visibility is sufficient to carry out work. Always do the following to prevent the work equipment from hitting other objects.
l When operating in tunnels, under bridges, under electric wires, or other places where the height is limited, be extremely careful not to let the blade hit anything. l To prevent accidents caused by hitting other objects, always operate the machine at a speed which is safe for operation, particularly in confined spaces, indoors, and in places where there are other machines. 1-11