g ~~~FJ’J~G; E;i;o follow these safety precautions may lead 7. PRECAUTIONS DURING OPERATION 7.3 TRANSPORTATION LOADING AND UNLOADING Loading and unloading the machine always involves potential hazards. EXTREME CAUTION SHOULD BE USED. When loading or unloading the machine, run the engine at low idling and travel at low speed. Perform loading and unloading on firm, level ground only. Maintain a safe distance from the edge of a road. ALWAYS use ramps of adequate strength. Be sure that the ramps are wide, long, and thick enough to provide a safe loading slope. Place blocks under both ramps to support them before loading and unloading.
When unloading on to an embankment or temporary structure, make sure that it has ample width, strength, and grade. To prevent the machine from slipping, be sure that the ramp surface is clean and free of grease, oil, ice and loose materials. Remove mud from the machine tracks. NEVER correct your steering on the ramps. If necessary, drive away from the ramps and climb again. After loading, block the machine tracks and secure the machine with tie-downs. Loading and unloading + See “13. TRANSPORTATION”. Tie-downs + See “13. TRANSPORTATION”.
Ra Distance between ramps AE50648B SHIPPING l When shipping the machine on a hauling vehicle, obey all state and local laws governing the weight, width, and length of a load. Also obey all applicable traffic regulations. l Take into account the width, height and weight of the load when determining the shipping route. Height, width, load of machine + See “13.4 PRECAUTIONS FOR TRANSPORTATION”. l When passing over bridges or structures on private land, check first that the structure is strong enough to support the mass of the machine. When traveling on public roads, check first with the relevant authorities and follow their instructions. 1-15