Komatsu — 11.5 LOCATION OF FIRE EXTINGUISHER

11. EXPLANATION OF COMPONENTS 11.4 FUSE BOX NOTICE l Before replacing a fuse, be sure to turn off the starting switch. l If the fuse blows again immediately after it is replaced, please contact your Komatsu distributor to have the system inspected. The fuses protect the electrical equipment and wirin,g from burning out. If the fuse becomes corroded, or white powder can be seen, or the fuse is loose in the fuse holder, replace the fuse. Replace a fuse with another of the same capacity. Fuse capacity and circuit name No.

1 FUSE CAPACITY 1 CIRCUIT NAME @ 1 20 A (yellow) 1 Head lamp, Rear working lamp @I 10 A (red) Horn AE218180 Water temperature gauge, Fuel gauge, Angle 0 10 A (red) select switch for hydraulic angle-tiltdozer (Back-up alarm) 0 20 A (red) Engine stop motor (for machines stopped by 0 30 A (green) starting switch) Power source for inspection and maintenance 11.5 LOCATION OF FIRE EXTINGUISHER When providing a fire extinguisher, install it in the position shown below. Position for installing fire extinguisher. AE140910 2-13