12. OPERATION 12.1.2 CHECK BEFORE STARTING CHECK COOLANT LEVEL, ADD WATER a WARNING Do not open the radiator cap normally. Check the coolant level at the sub tank while the engine is cold. 1. Open the top cover at the front of the machine body and confirm that the coolant level is between the FULL and LOW lines of sub tank @ (Shown at right). If it is lower than the LOW line, supply coolant to the FULL line through the coolant filler of sub tank @_ R FULL REMARK In summer, the coolant may flows out through the drain hose of the sub tank. This is caused by supply of too much coolant, and is not a problem. O-LOW After supplying coolant, close the cap securely.
AE217080 If the sub tank is empty, checkforwater leakage and confirm that the radiator main tank is full, then supply coolant to the radiator sub tank. After supplying coolant, close the top cover. 7 a WARNING -I CHECK FUEL LEVEL, ADD FUEL When adding fuel, never let the fuel overflow. This may cause a fire. If spilling fuel, thoroughly clean up any spillage. 1. Turn on the engine starting switch and check the fuel level with fuel gauge 0. After checking the fuel level, turn off the switch. AD217090 2. After completing work, fill the fuel tank through oil filler port 0. NOTICE For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 3.
After adding fuel, tighten the cap securely. Fuel capacity: 118 e (3.12 US gal, 26.0 UK gal) '\ 1 ~AE218220 NOTICE A clogged cap breather hole @ may stop the fuel flow to the engine. Check it from time to time and clean. AE217100 2-17