12. OPERATION CHECK OIL LEVEL IN STEERING CLUTCH CASE, ADD OIL 1. Open the cover, remove dipstick 0, and wipe the oil off with a cloth. Insert dipstick @ fully in the oil filler pipe, then take it out again. The oil level should be between the H and L marks on dipstick 2. 3. 0. If the oil level is below the L mark, add engine oil through oil filler 0 , NOTICE For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 4. If the oil is above the H mark, drain the excess engine oil from drain plug @, and check the oil level again. 5. If the oil level is correct, tighten the oil filler cap securely and close the cover.
REMARK l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. l If the machine is at an angle, make it horizontal before checking. CHECK BRAKE PEDAL TRAVEL If the travel of the brake pedal is not within a range of 110 - 162 rAwARNING . _ mm (4 33 - 6 38 in) the brakes and steermg WIII be too strong or they will not work properly. If the travel of the brake pedal is 163 mm (6.42 in) or more, carry out adjustment. 1. Depress the brake pedal all the way until it stops. AE21714B 2. Measure the pedal travel for being from 110 mm (4.33 in) to 162 mm (6.38 in) at the bottom end of the pedal. 3.
When this value exceeds 163 mm (6.42 in), or the brake fails to work adjust the pedal referring to “24.2 WHEN REQUIRED”. 2-20