Komatsu — 13.1 LOADING, UNLOADING WORK

13. TRANSPORTATION When transporting the machine, observe all related laws and regulations, and be careful to assure safety. 13.1 LOADING, UNLOADING WORK A WARNING When loading and unloading the machine, be very careful since it is dangerous work. When loading and unloading the machine, run the engine at a low speed and operate slowly. Make sure the ramp has sufficient width, length and thick- ness to enable the machine to be safely loaded and unloaded. If the ramp sags appreciably, reinforce it with blocks, etc. When loading and unloading the machine, park the trailer on a flat firm roadbed. Keep a fairly long distance between the road shoulder and the machine.

Remove the mud from the undercarriage to prevent the machine from slipping to the side on slopes. Be sure the ramp surface is clean and free of grease, oil, ice and loose materials. Never change the direction of travel when on the ramps. If it is necessary to change direction, drive off the ramps and correct the direction, then drive on to the ramps again. When loading or unloading, always use ramps or a platform carry out the operations as follows. Distance between ramps Properly apply the brakes on the trailer and insert blocks beneath AD052900 1. the tires to ensure that it does not move. Then fix the ramps in line with the centers of the trailer and the machine.

Be sure that the two sides are at the same level as one another. 2. Determine the direction of the ramps, then slowly load or unload the machine at 1st travel speed. 3. Load the machine correctly in the specified position on the trailer. 4. Use the first speed and run the engine at the low idling speed. When moving only a short distance, use the inching pedal. Although the brake can be applied with the inching pedal even on the ramps, be sure to depress the brake pedal with the right foot so that the machine will not fall over. NOTICE Limit the angle of the ramps to 15”. 2-46