36 Pre-Trip Inspection and Daily Maintenance Condition of Visible Components Suspension Check condition of springs (leaf or air), spring hangers, shackles and U- bolts. Axle alignment. Rear of engine: not leaking. Transmission: not leaking. If equipped with oil cooler, check for leaks or that air-to-air cooler is not blocked. Brakes Condition of brake drums. With brakes released, look for a noticeable gap be- tween lining and drum (This check cannot be made if dust covers are in place). Condition of brake hoses: check for any chafing. Check brake chamber mounting bolts and brackets. Check slack adjusters and chamber push rod travel.
With brakes applied or released, look for conspicuously dif- ferent positions of the slack adjusters. Check spring brakes. Check drive shaft. Exhaust system: secure, not leaking, not touching wires, fuel or air tubing. Frame and cross members: no bends, cracks or breaks. Air tubing and electrical wiring: se- cured against snagging and chafing. Step 5: Right Rear Vehicle Area Dual Wheels, One Or Two Axles Check condition of wheels and rims. Especially look for cracks, missing lockrings, bent or broken spacers, studs, clamps or lugs. Check condition of tires:
properly in- flated, no serious cuts, bulges, tread wear or any signs of misalignment; valve stems not touching wheels, rims or brake drums; valve caps in place and no objects stuck between the wheels. Step 6: Rear Of Vehicle Area Frame Area Frame or cross members not bent, cracked or otherwise damaged or missing. Check that air tubing and electrical lines are properly secured to the frame with no damage or chafing. Check that both tires are of same type, for example, not mixed radial and bias type and that their circumferences are matched. Lights and Reflectors Tail lights, brake lights and turn signal lights: operating, clean and proper color. Check wheel bearing and hub:
no obvi- ous leaking on outside or inside wheel.