c. FUEL FILTER 1. Using a filter wrench, remove cartridge (1) by turning it counterclockwise. 2. Fill the new cartridge with fuel and refit it after applying a dab of oil to the gasket face. * To refit the cartridge, place the gasket face in contact with the seal face of the filter stand, then screw up the cartridge 2/3 of a turn (be careful not to tighten it up excessively). 3. After replacing filter cartridge (I), loosen air bleed plug (2). 4. Loosen the knob of feed pump (3), then pump it up and down, and conti- nue until no more bubbles come out with the fuel from air bleed plug (2). 5. Tighten air bleed plug (2). * Always use genuine Komatsu filter cartridges.
* After replacing the filter cartridge, start the engine, and check that there is no leakage of oil from the filter seal surface. When starting the engine after it has run out of fuel, if the engine mis- fires, or black smoke comes out, bleed the air from the line as follows. 6. Loosen the connection of the fuel discharge port of the injection pump, and bleed the air in the same way as for the fuel filter. 7. After bleeding the air, tighten the fuel discharge port, then push in the knob of the feed pump and tighten it. - 134-