e. CORROSION RESISTOR 1. Screw in valve (1) at the top of the corrosion resistor. 2. Using a filter wrench, turn cartridge (2) to the left and remove it. 3. Coat the seal surface of the new cartridge with engine oil. t To prevent overtightening, bring the packing surface into contact with the seal surface of the filter holder, then tighten about 2/3 of a turn. 4. Open valve (1). t Use a genuine Komatsu cartridge. 5. Start the engine and check that there is no leakage of water from the seal surface. - 138-