13. To remove the air in the cooling water, run for five minutes at low idl- ing, then for another five minutes at high idling. When doing this, leave radiator cap (2) off. 14. After draining off the cooling water of sub-tank (5), clean sub-tank and refill the water between H and L level. (5): Sub-tank 15. Stop the engine, wait for about three minutes, add cooling water to the specified level, then tighten cap (2). b. CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT Checking Whenever the red piston in dust indicator (1) appears, clean the air clean- er outer element. Stop the engine when cleaning the element. Cleaning or replacing outer element 1.
Remove wing nut (2), then remove cover (3), and take out the outer ele- ment. 2. Clean the air cleaner body interior and the removed cover. 3. Clean and inspect the element. (See the item “Cleaning outer element” for cleaning procedure.) 4. Install the cleaned element. 5. Push the dust indicator reset button to return the red piston to the origin- al positon. * Replace the outer element which has been cleaned 6 times repeatedly or used throughout a year. Replace the inner element at the same time. * Replace both inner and outer element when the dust indicator red piston appears soon after installing the cleaned element even though it has not been cleaned 6 times.
* Remove one seal from the outer element. The number of times the outer element has been cleaned can be seen by the number of removed seals. * Check inner element mounting nuts for looseness and, if necessary, re- tighten. * When inspecting or cleaning the air cleaner, remove evacuator valve (5) and clean with compressed air. t Replace seal washer (4) or wing nut (2) if they are broken. - 150-