* The life of the point can be lengthened and the frequency of its replace- ment can be reduced by turning it upside down so that it will wear * When replacing the point, replace the rubber pin and lock pin with new evenly. ones. This will prevent the point from falling. g. REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth before the wear reaches the adapter. * When removing pin (2), use a bar that is slightly thinner than the pin, 1. Remove pin (2) mounting the bucket, then remove tooth (1). 2. Fit new tooth (1) in adapter (3), push in pin (2) partially by hand, then then tap and remove from the opposite side. knock in with a hammer. - 160-