Komatsu — ADJUSTMENT

ADJUSTMENT ADJUSTMENT OF BUCKET CLEARANCE If there is excessive free play on the coupling section of the bucket and arm, adjust the bucket clearance in the following manner. t Set the work equipment in the posture as above. 1. Loosen 4 bolts (2), bolt (3) and plate (1). 2. Take out shims (4) equivalent in size to free play “a”. * The thickness of shim (4) is 0.5 mm or 1 mm each. * When free play “a” is less than 0.5 mm, do not compress the shims by tightening bolt (2). 3. Tighten 4 bolts (2) and bolt (3). Then, clearance “b” becomes larger and free play “a” is removed. or When adjusting, set the work equipment in the posture shown in the dia- gram below. (5): Bucket (6): Bush (7): Arm -164-