FRONT WINDSHIELD It is possible to store (pull up) the front window (top) in the roof of the operator’s compartment. When opening 1. Stop the machine on flat ground, lower the work equipment to the ground, and stop the engine. 3. Disconnect the wiring for the wiper motor from socket (B). 2. Lock the left and right work equipment control levers and travel levers. 4. Pull lock pins (A) at the top left and right sides of the front window to the inside to release the lock. 5. From the inside of the operator’s cab, hold the bottom grip with the left hand and the top grip with the right hand, pull up the window, and push 6. Lock with lock pins (A) on the left and right sides.
it in fully until it is locked by catch (C). When closing 1. Stop the machine on flat ground, lower the work equipment to the ground, and stop the engine. 3. Release lock pins (A). 2. Lock the left and right work equipment control levers and travel levers. 4. Hold the grip at the bottom of the front window with your left hand and the grip at the top with your right hand, release the lock of catch (C) with your right thumb, then pull the top grip slowly and lower the front window. When releasing the lock of catch (C), push release lever (D) in 5. Lock securely with lock pins (A) at the left and right sides. the direction of the arrow to release the lock. 6.
Connect the wiper motor wiring to socket (B). Removing front window (bottom) the front window can be removed. Store the removed bottom part of the With the front window open, remove lock pin (E), and the bottom part of front window at the rear of the operator’s cab. - 34 -