L: PERMISSIBLE WATER 1. Do not immerse the machine in water by more than the permissible depth (under swing circle (1)). In addition, properly grease parts which have been immersed in water for a long time, until the old grease comes out from the bearings (vicinity of bucket pins, swing circle system, etc.). 2. When driving the machine out of water, if the angle of the machine ex- ceeds 15”, the rear of the upper structure will go under water, and water will be thrown up by the radiator fan. This may cause the fan to break. Be extremely careful when driving the machine out of water. M: PRECAUTIONS WHEN TRAVELING UP OR DOWN HILLS 1. When traveling on a steep downhill grade.
When traveling down a hill, adjust the speed with the travel lever and fu- el control dial. If the grade exceeds 15”, set the machine in the posture shown in the di- agram above, and reduce the engine speed. A Do not travel on slopes of over 30” as there is danger that the machine may overturn. 2. Braking when traveling downhill To brake the machine during downhill runs, put the traveling and steering lever in the neutral position. This will cause the brake to be automatically applied. 3.
If shoes slip When climbing a hill, if the shoes slip or the travel motor relieves, pre- venting the machine from climbing by means of the tracks alone, it is possible to use the force of the arm as an -aid. 4. If engine stops When the engine stops on a slope, move the traveling and steering levers to neutral position and lower the bucket. Thereafter, turn starting key to START. 5. Matters for attention at special work sites a) If operation is executed in water, if the work equipment fixing pins come in contact with water, greasing is to be performed after every under-wa- ter operation.
b) Greasing of the work equipment fixing pins is to be performed every time before heavy digging or deep digging. * After greasing is done, the boom, arm and bucket are to be operated several times. This should be followed by re-greasing. - 74 -