TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle laws and vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the machine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the following for the sake of safety. Properly apply the brakes on the trailer and insert blocks beneath the tires to ensure that it does not move. Then fix the gangplank in line with the centers of the trailer and the machine. Make sure the gangplank has sufficient width, length and thickness to enable the machine to be safely loaded and unloaded.
If the gangplank sags appreciably, reinforce it with blocks, etc. Turn the AUTO-DECEL switch OFF, and set the travel speed switch to the Lo position. Determine the direction of the gangplank, then slowly load or unload the machine. A Remove the mud from the undercarriage to prevent the machine from slipping to the side on slopes. * * Move the machine backward to get on the trailer. Do not on any account change the direction of the machine while it is on the gangplank. To change the direction of the machine, first take it down from the gangplank. Correctly load the machine onto the specified part of the trailer.
After loading the machine, fully extend the bucket and arm cylinders, then slowly lower the boom. When transporting the machine, place rectangular timber under one end of the bucket cylinder to prevent it touching the ground, thereby saving it from possible damage. When transporting the machine, place rectangular timber underneath the front and rear track shoes to prevent the machine from moving about. Also, hold it down with chains or rope. Be particularly careful to ensure that the machine does not slip sideways. Lock all the control levers securely with the lock lever. Determine the route for transporting the machine by taking into account the width, height and weight of the machine. 4.
* 5. 6. * - 85 -