Mounting and Dismounting SAFETY When mounting or dismounting this machine, always be sure the work equipment is fully lowered to the ground; the engine is OFF; and the parking brake is set. Use all hand holds and step plates on your machine (marked by arrows in the graphic). Never climb on the engine hood or covers where there are no non- slip pads. Never jump off or on to the machine. Never move from the step at the rear of the machine or the step at the side of the cab to stand on top of the tire. If there is any oil, grease, or mud on your shoes, wipe it off immediately before getting on the machine.
If there is any oil, grease, or mud on the rails, steps, or platforms, wipe it off immediately before getting on the machine. Always keep these areas clean and in good condition. Never get on or off a moving machine. These actions may lead to serious injury. Always bring the machine to a full stop. Never get on or off the machine while holding tools in your hand. When entering the cab, stand on the top step before opening the door. When getting on or off the machine, always face the machine and maintain a Three-Point Contact (both feet and one hand, or one foot and both hands) with the handrails, steps, and platforms to ensure that you support yourself properly.
When entering the cab and opening the cab door, push the door open until it is securely into door latch (1) and held in position. Use the handrails on the inside of the door while entering or exiting the cab. Never hold any control levers or the steering wheel when getting on or off the machine. WA380-6 1-15