Handling Accumulator and Gas Spring SAFETY This machine is equipped with an accumulator. Even after the engine has stopped, it is possible to operate the work equipment control lever in the LOWER direction for a short time to allow the work equipment to go down under its own weight. After stopping the engine, set the work equipment lock lever to the LOCK position and turn the parking brake switch ON. The accumulator and gas spring are charged with high-pressure nitrogen gas. If the accumulator is handled mistakenly, it may cause an explosion that could lead to serious personal injury or death. For this reason, always observe the following precautions: Do not dissemble the accumulator.
Do not expose the accumulator to high heat or an open flame. Do not weld on the accumulator. Do not drill or cut the accumulator. Do not strike or crush the accumulator. When replacing or disposing of the accumulator, always release the nitrogen pressure from the chamber. Disposal of Waste Materials Always drain fluids from your machine into the appropriate containers. Never drain fluids directly onto the ground. Never dump waste fluids in a sewer system, on the ground, in rivers, etc. Obey appropriate laws and regulations when disposing of harmful objects such as oil, fuel, filters, batteries, coolant, brake fluid, and hydraulic oil. WA380-6 1-45