5. TROUBLESHOOTING a. ENGINE Hard Starting Check the fuel level in the tank. No fuel in the tank Add fuel and start the engine. I Sufficient fuel in the tank. Loosen the carburetor drain screw and check whether fuel reached the carbu- retor. Not reaching the carburetor. Check for collapsed or pinched fuel line. Check that the fuel tank vent knob is open. Check for air leaks past primer bulb. Squeeze the primer bulb and be sure that the fuel is reaching each part of the fuel system. Check for clogged fuel tubes, strain- er and connector. Replace the fuel pump (P. 5-12*’). Reaching the carburetor, I Disconnect the spark plugs and check for wet or fouled electrode.
> Check for blockage in the carburetor port and nozzle. )r If excessively wet, check the carbu- retor for flooding. Clean the electrode and restart the engine. If the engine does not restart, try to start the engine with the throttle 1/4 open. If the engine does not start yet, open the throttle gradually wider and determine the throttle position where the engine starts. i 1 Perform spark test (P. 2-13*1). sparks spark test near the plug holes. bleshooting (P. 2-10). Good sparks - High compression -j, Check for carbon deposits in the cam- bustion chamber. Check compression of each cylinder - (P. 2-11 *l).
Normal compression Reinstall the spark plugs securely and restart the engine according to the starting procedure. *1: Indicates reference page of the base shop manual. 2-7