B F25 D*B F30D b. IGNITION SYSTEM Weak or No Sparks Measure the spark plug gap and perform the spark test (P. 2-13 *l). Spark plug gap: 0.6 - 0.7 mm (0.24 - 0.28 in) Perform the spark test again using a new spark plug. Good sparks Replace the spark plug with a new one. Check that the switch clip is installed on the emergency stop switch correctly. Disengaged. Install the clip securely. emergency stop switch and perform the spark test again. Abnormal - Replace:(Remote control type: P. 1441, Long tiller handle type: P. I No spark 1 5-6). Disconnect the power coil 2P connector and measure resistance between the terminals. Standard resistance: 6.1 2 - 7.48 62 Power coil faulty. Replace: (P.
6-1*1 See EXCITER COIL replacement.) Abnormal + measure resistance between the terminals. Pulser coil faulty Replace: (P. 6-3*1) Abnormal > Primary: 0.1 9 - 0.23 D Ignition coil faulty. Replace: (P. 16-3*1) Measure resistances between each ter- minal of the CDI unit (P. 16-1 and 2). I Abnormal CDI unit faulty. No magnetic force - Flywheel faulty. Replace (P. 1631) Replace: (P. 6-1) I Normal * 1 Replace or repair the wire harness. *I : Indicates reference page of the base shop manual. 2-1 0