BF25D.B F30D Trim Angle Sensor Installation I [2] TRIM ANGLE SENSOR Set the corrugated tube at the wire holder with the slit facing to the wire holder. . 6 x 2 0 m m [4]6 mm WASHER(2) HEX. BOLT Trim Angle Sensor Wire Installation [l] TRIM ANGLE SENSOR WIRE [2] WIRE BAND (2) Set the trim angle sensor side positioning tape (White) on the trim angle sensor wire by aligning its end with the end of the set plate, and secure with the wire band. Secure the power trim/tilt motor wire and trim angle sensor wire by securing with the wire band clip in the center of the positioning tape (White).
[31 POSITIONING TAPE (Align the both ends with the both ends of the set plate.) [4] WIRE BAND CLIP Trim Angle Sensor Wire 81 Power TriMilt Motor Wire Installation Set the motor cord bushing aligning the boss of the motor cord bushing with the groove in the left stern bracket. I [11 _ . TOR CORD BUSHING R TRIMKILT R WIRE Secure the power trimhilt motor wire and trim angle sensor wire against the left stern bracket using the wire band in the center of the positioning tape. f [31 TRIM ANGLE SENSOR WIRE - [41 POSITIONING TAPE (Align the end with the end of the set plate.) I [5] WIRE BAND 13-1 0