15.THROllLE CABLE BRACKETEHIFT LEVEW TILLER HANDLE (TILLER HANDLE TYPE ONLY) BF25DoBF30D 1 1. LONG TILLER HANDLE 1. LONG TILLER HANDLE a. REMOVAL 6 x 28 ( 2 ) h [I1 SEPARATOR COVER 1) Remove the engine cover (P. 4-1 of the base shop manual). 2) Set the shift lever in the “N” (Neutral) position. 3) Remove the two 6 x 28 mm flange bolts, two 6 x 40 mm hex. bolts and two 6 mm washers, and remove the separator cover. [3]6 mm WASHER(2) [2] 6 x 40 mm HEX. BOLT 4) Remove the 6 mm lock pins and 6 mm washers, then disconnect the shift cable and throttle cable. [l] THROTTLE CABLE [2] SHIFT CABLE 5) Open the wire band clip and release the tiller handle wire harness and main wire harness.
6) Remove the tiller handle wire harness 14P connector from the connector bracket, and disconnect the con- nector. 15-1