BF25D/30D BF25D-BF30D — Sep '94

16. ELECTRICAL EQUIPMENT ~~ 1. CDI UNIT 2. POWERCOIL 3. SE THERMAL VALVE HEATER COIL 1. CDI UNIT a. INSPECTION Measure the resistance between the CDI unit terminals. CAUTION Be careful not to touch the metallic part of the tester probe with your body, otherwise correct resistance value cannot be obtained. Use only the specified tester shown below to obtain correct resistance value. - Hioki tester: Model 3030 Read the tester manufacturer’s operation instruc- tions carefully before operation with the tester. Be sure the tester’s battery is fully charged and check the meter before using the tester. The tester needle can sway large and it returns slowly effected by the internal condenser.

Wait until the needle stabilizes before measurement. unit: k Q I [l] Tester probe( -I-) I 16-1