MAN — Removing and installing timing case

Removing and installing timing case Removing timing case Fig. 1 The following engine components / auxiliary units are attached to the timing case and have to be re- moved: D Starter D Raw-water pump D Hydraulic pump if fitted D Fuel filter D Oil and coolant lines D Bracket for exhaust manifold D Engine mounts if fitted 1 Fig. 2 Remove timing case cover (13 mm). Note: Pipelines are attached to the timing case cover. To facilitate reassembly, memorise, note down in a drawing or take a photo of the position of the brackets, pipe clamps, spacer sleeves etc. 2 Fig. 3 Remove flywheel (see page 84). Remove mounting bolts from timing case (17 mm).

The timing case is bolted to the oil pan at the bottom. 3 Fig. 4 Danger: The timing case is heavy. Replace two opposite bolts with guide pins M12 x 1.5 А if necessary. 2 1 Two long M10 bolts Б screwed into the dead-end holes in the flange-on face facilitate handling the timing case. 1 4 123